6
LOADING THE RACKS
CUTLERY RACK
The rack was designed to house the
cutlery.
Arrange the cutlery as shown in the
figure.
A separate arrangement of the cutlery
makes collection easier after washing
and improves washing and drying
performance.
Knives and other utensils with sharp edges must be positioned with the
blades facing downwards.It must only be positioned at the front of the
lower rack
The geometry of the rack makes it
possible to place such small items as
coffee cups in the area in the middle.
UPPER RACK
Load delicate and light dishes: glasses, cups, saucers, low salad bowls.
(loading example for the upper rack)
ADJUSTING THE HEIGHT OF THE UPPER RACK
The height of the upper rack can be adjusted: high position to place
bulky crockery in the lower basket and low position to make the most
of the tip-up supports by creating more space upwards and avoid
collision with the items loaded into lower rack.
The upper rack is equipped with a Upper Rack
height adjuster (see figure), without pressing
the levers, lift it up by simply holding the rack
sides, as soon as the rack is stable in its upper
position.
To restore to the lower position, press the
levers A at the sides of the rack and move the
basket downwards.
We strongly recommend that you do not
adjust the height of the rack when it is
loaded.
NEVER raise or lower the basket on one side only.
FOLDABLE FLAPS WITH ADJUSTABLE POSITION
The side foldable flaps can be positioned at
three different heights to optimize the
arrangement of crockery inside the rack.
Wine glasses can be placed safely in the foldable
flaps by inserting the stem of each glass into the
corresponding slots.
For optimum drying results incline the foldable
flaps more. To change the inclination, pull up
the foldable flap, slide it slightly and position it
as you wish.
LOWER RACK
For pots, lids, plates, salad bowls, cutlery etc. Large plates and lids
should ideally be placed at the sides to avoid interferences with the
spray arm.
(loading example for the lower rack)
The lower rack has tip-up supports which can be used in a vertical
position when arranging plates or in a horizontal position (lower) to
load pans and salad bowls easily.
POWER CLEAN IN LOWER RACK
Power Clean® uses the special water jets in
the rear of cavity to wash more intensively
the high dirty items. The lower rack has a
Space Zone, a special pull-out support in
the rear of the rack that can be used to
support frying pans or baking pans in upright position, thus taking up
less space.
Placing the pots/casseroles faced to the Power Clean® component
please activate the POWER CLEAN on the panel.
How to use Power Clean®:
1. Adjust the Power Clean®
area (G) folding down the
rear plate holders to load
pots.
2. Load pots and casseroles
inclined vertically in
Power Clean® area. Pots
have to be inclined
towards the power water
jets.
