ARISTON DISHWASHER - Instructions for installation and use
15
D
ISHWASHER
You have loaded your dishes and you now have to set the
wash cycle. It takes just one minute to learn how
Starting the dishwasher
Ready, steady, go!
First of all.
Insert the plug into the
electricity socket to power the
dishwasher. Turn on the water
tap completely and press the
Stand-by button
. The
display turns on and 4 dashes
appear: these indicate that the
dishwasher is awaiting
instructions.
Selecting the wash cycle
Select the wash cycle
by pressing this button
Each time you press the button,
a beep will sound and the
corresponding symbols will light up
in sequence:
choose the cycle you deem
most suited to the type of
dishes to be washed (take a
look at page 17, where you will
find the wash cycle table). Keep
the Start button
pressed for
a few seconds and the wash
cycle begins, but if you have left
the dishwasher door open, the
word DOOR will be displayed;
shut it and press the same button
again.
A beep sounds and then the
wash cycle begins and only the
symbol corresponding to the
wash cycle selected is
displayed.
You can see the amount of time
left until the end of the wash
cycle on the counter. Do not
expect a precise countdown as
the wash cycle starts with an
estimated cycle time that is
updated, thanks to the sensor
it is fitted with, as the cycle
progresses, according to a
number of parameters that
ensure maximum wash
efficiency.
The dishwasher keeps you
informed.
Your dishwasher is
fitted with indicator
lights (H) which light
up to indicate the
cycle phase under
way.
Here are the symbols
corresponding to
each cycle phase:
At all times, your dishwasher tells
you which cycle phase is under
way.
Modifying a wash cycle in
progress.
But if you have chosen the wrong
cycle, not to worry! You can modify
the wash cycle in progress, if it has
only just started. Keep the Reset
button
pressed for about 2
seconds: a prolonged beep will
sound, followed by three short
beeps. Indicator light I turns off
and the 4 dashes appear to indicate
that all the settings have been
cancelled. You are now free to re-
set the correct wash cycle.
Youve left out a dish?
Well, it happens to everyone.
Interrupt the wash cycle by
pressing the Stand-by button, insert
the dish you had forgotten and
press the same button again. The
cycle will start up from where you
interrupted it.
P
Make sure the wash
cycle has ended before
removing the dishes!
Finished?
The end of the wash cycle is
indicated by two short beeps and
the word END flashes on the
display.
Turn off the water tap.
Wait a few minutes before
unloading the dishes: they are very
hot! If you wait a little while, they
dry better.
Empty the lower rack first.
Theres been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and then
restarts when the electricity comes
back on or when you shut the door.
Everything is under control!
Have you left the
dishwasher door open?
The word DOOR flashes on the
display. Shut the appliance door and
the wash cycle will start up again.
Warning:
Turn the display off by pressing
button A, unplug the appliance
from the electricity socket to cut
off the power supply; the power
supply cable should
consequently be easily
accessible.
