17
Close the dishwasher door and turn on the
water tap.
1. Press the ON/OFF button to switch on the
appliance. One of the programme indicator
lamps will illuminate.
2. Select the programme required by turning the
programme selector knob. The
corresponding indicator lamp will illuminate.
If required, select any additional functions.
3. Press the Start button to start the selected
wash programme. The Start indicator lamp will
illuminate. Once set, the programmed data
cannot be altered by turning the programme
selector knob or pressing the buttons.
Note: Once the Start button has been
pressed, the dishwasher memorises all the
programmes selected. The selected
programmes are also saved in the event of
power failure.
4. To change the programme selected, press
the Start button for about 5 seconds until the
Start indicator lamp switches off. Select a
new programme using the programme
selector knob and press the Start button.
5. The End indicator lamp (if fitted) illuminates
briefly and the Start indicator lamp switches
off to indicate the end of the programme.
6. Press the ON/OFF button to switch off the
dishwasher (only after the End indicator lamp
has switched on or the Start indicator lamp
has switched off). All the indicator lamps
switch off.
Note: If the dishwasher is switched off
during a wash programme, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
HOW TO USE THE DISHWASHER
1
2
3
4
5/6
94003-gb.fm5 Page 17 Wednesday, September 26, 2001 6:23 PM
