44
Close the dishwasher door and turn on
the water tap.
1.
Press the
ON/OFF button
to switch on the
dishwasher. One of the programme indicator
lamps will illuminate.
2.
Select the required programme by pressing
the
programme button
. The corresponding
indicator lamp will illuminate.
If required,
select any additional functions.
3.
Press the
Start
button to start the selected
wash programme. The corresponding
indicator lamp will illuminate. Once set, the
programmed data cannot be altered by
turning the programme selector knob or
pressing the buttons.
Note:
Once the
Start
button has been
pressed, the dishwasher memorises all the
programmes selected. The selected
programmes are also saved in the event of
power failure.
4.
To change the programme selected, press
the
Start
button for about 5 seconds until the
Start
indicator lamp switches off. Select a
new programme using the
programme
button
and press the
Start
.
5.
The
End
indicator lamp (if fitted) illuminates
briefly and the
Start
indicator lamp switches
off to indicate the end of the programme.
6.
Press the
ON/OFF
button to switch off the
dishwasher (only after the
End
indicator lamp
has switched on or the
Start
indicator lamp
has switched off). All the indicator lamps
switch off.
Note:
If the dishwasher is switched off
during a wash programme, when switched
on again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
HOW TO USE THE DISHWASHER
1
2
3
4
5/6
94002-gb.fm5 Page 44 Wednesday, September 26, 2001 6:18 PM
