17
Close the dishwasher door and turn on the
water tap.
1.
Programme selector knob clicks out.
Press and release the programme selector
knob. The knob clicks out.
2. Switching on the dishwasher and
selecting the programme.
Select the programme required by turning
the programme selector knob. The
corresponding indicator lamp will illuminate.
If required, select any additional functions.
Press the programme selector knob.
Press the programme selector knob fully
down and then release.
The knob remains in the pressed position.
Note: The pressed or released position of
the programme selector knob has no effect
on the operation of the dishwasher.
3. Press the
Start button to start the selected
wash programme. The Start indicator lamp
will illuminate.
Once set, the programmed data cannot be
altered by turning the programme selector
knob or pressing the buttons.
Note: Once the Start button has been pressed
the dishwasher memorises all the programmes
selected. The selected programmes are also
saved in the event of power failure.
4. To change the programme selected, press the
Start button for about 5 seconds until the
Start indicator lamp switches off. Click out the
programme selector knob, select the new
programme and press the Start button. Re-
press the progamme selector knob. The End
indicator lamp (if fitted) illuminates briefly and
the Start indicator lamp switches off to
indicate the end of the programme.
5. Click out the programme selector knob
to
switch off the dishwasher.
Turn the programme selector knob anti-
clockwise.to the “0” position (only after the
End indicator lamp has switched on or the
Start indicator lamp has switched off). All the
indicator lamps switch off. Re-press the
programme selector knob.
Note: If the dishwasher is switched off
during a wash programme when switched on
again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
HOW TO USE THE DISHWASHER
1
2
3
4
5
