26
INSTALLATION
•
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
•
Make sure that all four feet are resting firmly
on the floor and check that the appliance is
perfectly level (use a spirit level).
•
If the floor is uneven, adjust the levelling feet
as required (never use pieces of wood,
cardboard or similar materials).
1.
Slacken the locknut using the spanner
supplied.
2.
Adjust the height of the foot, tuning it by hand
or with a suitable tool (e.g. pliers)
3.
Tighten the lock nut anticlockwise towards
the appliance housing in order to avoid the
risk of vibration and operating noise.
•
If the appliance is to be installed on a wooden
floor, distribute the weight by placing it on a
60x60 cm sheet of plywood at least 3 cm in
thickness. Secure the plywood sheet to the
floor.
WORKTOP / COVER PANEL
The appliance must only be installed beneath
a continuous fitted kitchen worktop.
The appliance must be installed using the
cover panel UBS set.
•
Pull out the mains plug.
1.
Unscrew the worktop fixing screws from the
rear of the appliance.
2.
Slide the worktop fully backward and lift it
upwards to remove.
Install the cover panel according to the
instruction.
3.
Refit the fixing screws and tighten them.
BUILD-UNDER OPENING DIMENSIONS
Width 600 mm
Height 825 mm
Depth 600 mm
AUXILIARY CIRCUIT BREAKER:
The worktop or cover panel must be
reinstalled before the appliance is connected
to the mains.
INSTALLATION INSTRUCTIONS
