27
INSTALLATION
•
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
•
Make sure that all four feet are resting firmly on the
floor and check that the appliance is perfectly level
(use a spirit level).
•
If the floor is uneven, adjust the levelling feet as
required (never use pieces of wood, cardboard or
similar materials).
1.
Slacken the locknut using the spanner supplied.
2.
Adjust the height of the foot, tuning it by hand or
with a suitable tool (e.g. pliers)
3.
Tighten the lock nut anticlockwise towards the
appliance housing in order to avoid the risk of
vibration and operating noise.
•
If the appliance is to be installed on a wooden
floor, distribute the weight by placing it on a
60x60 cm sheet of plywood at least 3 cm in
thickness. Secure the plywood sheet to the floor.
WORKTOP / COVER PANEL
The appliance must only be installed beneath a
continuous fitted kitchen worktop.
The appliance must be installed using the cover
panel UBS set.
•
Pull out the mains plug.
1.
Unscrew the worktop fixing screws from the rear of
the appliance.
2.
Slide the worktop fully backward and lift it upwards
to remove.
Install the cover panel according to the instruction.
3.
Refit the fixing screws and tighten them.
BUILD-UNDER OPENING DIMENSIONS
Width 600 mm
Height 825 mm
Depth 600 mm
AUXILIARY CIRCUIT BREAKER:
The worktop or cover panel must be reinstalled
before the appliance is connected to the mains.
INSTALLATION INSTRUCTIONS
