17
– that the drain pump is not blocked by a fo-
reign object. Clean the pump, see chapter on
Maintenance.
– that the drain hose is not kinked.
After doing this, run programme P8. If there is
still a problem, call service.
Machine not filling. Fault in water supply, check:
- is the tap on the water pipe open?
- is the filter in the machine’s water intake bloc-
ked? Turn off the tap. Unscrew the hose and
check.
is flashing in the bottom right corner of the
display. The programme has tried to start but
the door is open. Close the door and start again.
0000 is flashing at the top right of the display.
The machine has not spun.
1. The machine has a built-in imbalance sensor
that reduces the speed or prevents spinning if
the load is poorly distributed. Switch off the
power switch,
, then switch it on again.
Open the door and redistribute the load.
2. After doing this, run programme P8.
If there is some other fault, call service and say
which error message appears in the display.
THE DISPLAY IS LIGHTING WHEN A PROGRAMME
IS SELECTED, BUT NO CHARACTERS OR DIGITS
ARE SHOWN
No characters or digits are shown on the dis-
play when a locked programme is selected.
To unlock a programme, see Changing set-
tings.
WRONG LANGUAGE DISPLAYED
If the display language has changed for some
reason you can go back to the original langua-
ge.
The languages you can choose between are
Dansk, Deutsch, English, Espanol, Français,
Italiano, Nederlands, Norsk, Portugués, Suomi
and Svenska.
To change language do as follows:
Switch off the power switch, , then switch
it on again so that the machine is in start-up
mode.
Press the
P8
button five times, then press
the
P1
button five times. You have to comple-
te these ten button presses within fifteen se-
conds.
Within three seconds of pressing the
P1
button for the fifth time you should then select
the language you want by pressing the
P6
or
P7
buttons.
TROUBLESHOOTING WASHING MACHINE
