Productos de la Marca Whirlpool

User manual

CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER

6. Remove the kick panel: Using a screwdriver, do that which

is shown in the following gure.

7. Container for the drained water:

Place a low and wide container under the water filter

in order to collect the residual water.

8. Drain the water:

Slowly turn the lter counter-clockwise until all the

water has come out. Allow the water to ow out without

removing the lter. Once the container is full, close the

water lter by turning it clockwise. Empty the container.

Repeat the procedure until all the water has been

drained.

9. Removelter:Layacottonclothbeneaththewaterlter,

which can absorb a small amount of rest water. Then

remove the water lter by turning it out anticlockwise.

10. Clean the water lter: remove residues in the lter and

clean it under running water.

11. Insert the water filter and reinstall the plinth: Reinsert

the water lter again by turning it in clockwise direction.

Make sure to turn it in as far as it goes; the lter handle

must be in vertical position. To test water tightness of

the water lter, you can pour about 1 liter of water into

the detergent dispenser. Then reinstall the plinth.

Switch off and unplug the washing machine before cleaning the water filter or draining residual water. If you used

a hot wash programme, wait until the water has cooled down before draining any water.

Clean the water filter regularly, to avoid that the water cannot drain after the wash due to obstruction of the filter.

If the water cannot drain, the display indicates that that the water filter may be clogged.