4
1. Before starting washing, check the following;
Connect the water supply hose and open the water tap.
Connect the power cord to the power supply outlet.
Lay the drain hose(A) down toward a sinkhole.
Place the drain hose(A) in sink or bath about
70~80cm above the ground.
2. Set the WASH SELECTOR KNOB to the desired mode.
‘NORMAL or HEAVY’
3. Set the CYCLE SELECTOR KNOB to ‘WASH.RINSE’.
(In case no drain pump.)
(‘WASH’ In case drain pump.)
4. Set the CYCLE SELECTOR KNOB to ‘WASH.RINSE’.
(In case no drain pump.)
(‘WASH’ In case drain pump.)
4. Set the CYCLE SELECTOR
KNOB to ‘WASH.RINSE’. (In
case no drain pump.)
(‘WASH’ In case drain pump.)
6. Fill water in the wash tub
and add the detergent.
7. Set the WASH TIMER 1-35 minutes.
SOAK
Set the WASH TIMER to the point
more than “15” for SOAK function.
If the WASH TIMER is set to the
point less than “15”, it leads to
WASH only. (No SOAK)
If Although the machine may stay still maximum
5 minutes, if the WASH TIMER is indicated over 15
minutes position, it is just in the process of soaking
and not a breakdown.
8. After washing,set the CYCLE
SELECTOR KNOB to ‘DRAIN’ for
drain.
9. Soak-Washing
1) Place clothes into the WASH TUB.
2) Turn on tap or use bucket to ll the WASH TUB with
desired amount of water.
3) Put detergent depending on the water volume and
detergent package indications.
4) Set WASH TIMER to point between “15” to “35” in the
timer.
Soak-Washing automatically starts the wash (15
min.) after the soak (2 to 20 min.) is completed.
The SOAK function (20 min.) repeats the cycle that is
1.5 ~ 2.0 min. turning and the next 5 min. resting 3
times.
WASHING PROCEDURE
TO WASH .........................................................................................................................................................................
WT13J7N-01941K-03_EN.indd 5 2013-05-23 �� 5:26:28
