4.CYCLE SELECTOR
This is used to set the Washing/Rinsing or Draining.
5. SPIN DRY TIMER
This is used to set the spin time 1-5 minutes.
1.WASH TIMER
This is used to set the wash time, 1-15 minutes.
2.WASH CONTROL
You can wash laundry effectively by various methods.
3.SPIN DRY TIMER
This is used to set the spin time 1-5 minutes.
4.WATER INTAKE
Connect water inlet to a tap with a suitable.
5.
DRAIN SELCTOR
Be sure to press the selector knob to ‘WASH’ while washing.
CONTROL PANEL WASHING PROCEDURE
FRONT PANEL
REAR PANEL
1.WATER
SELECTOR
During washing, WATER SELECTOR KNOB
should be selected to wash. During spin rinsing,
WATER SELECTOR KNOB should be selected to spin.
2.WASH TIMER
This is used to set the wash time, 1-15 minutes.
3.WASH
SELECTOR
You can wash laundry effectively by various methods.
Before starting washing, ; Connect the water supply hose and open the water tap.
check the following - Lay the drain hose down toward a sinkhole.(In case no drain pump)
- Place the drain hose in sink or bath.(In case drain pump)
- Connect the power cord to the power supply outlet .
1. Set the CYCLE SELECTOR KNOB to
‘WASH.RINSE’.
(in case drain pump ‘WASH’)
5. Put the cloths into
the wash tub and
set the same water
pressure to fill the
tub so as not to
exceed ‘H3’level.
6. Set the WASH TIMER
1-15minutes.
7. After washing, set the
CYCLE SELECTOR KNOB
to ‘DRAIN’ for drain.
2. Set the WATER SELECTOR
KNOB to WASH .
3. Select the
WASH SELECTOR KNOB
for desired mode.
TO WASH
SW-903(P)
4. Fill water in the wash
tub to the‘L1’ lower
water level by carefully
adjusting the tap water
and add the detergent.
1. Select the WASH CONTROL KNOB
for desired mode.
5. Set the WASH TIMER
1-15minutes.
6. After washing Press the
DRAIN SELECTOR KNOB to
‘DRAIN’ for drain .
2. Press the
DRAIN SELECTOR KNOB
to ‘WASH’ .
3. Fill water in the wash tub
to the ‘L1’ lower water
level by carefully
adjusting the tap water
and add the detergent.
4. Put the cloths into the
wash tub and set the
same water pressure
to fill the tub so as not to
exceed ‘H3’level.
(A)Type
(A)Type
(B)Type
(B)Type
SWT90C1(P) / SWT90C2(P)
SWT10H0(P) /SWT10H1(P) /SWT10H2(P)
