4
CONTROL PANEL
WASHING PROCEDURE
1. WASH TIMER
This is used to set the wash time, 1-15 minutes.
2. WASH SELECTOR
You can wash laundry effectively by various
methods.
3. CYCLE SELECTOR
This is used to set the Washing/Rinsing or
Draining or Spining.
4. WATER INTAKE
Connect water inlet to tap with a Suitable.
5. DRAIN/SPIN TIMER
This is used to set the spin time 1-5 minutes.
Before starting washing, check the following ;
Connect the water supply hose to the water tap. Leave a tap open.
Plug the power cord in. Make sure to lay down the drain hose.
Put the laundry into the washer and add detergent, too.
Be careful not to overload, Use right detergent for the fabrics you are washing.
TO WASH
1. Set the CYCLE SELECTOR KNOB
to “WASH / RINSE”
2. Select the WASH SELECTOR
KNOB for desired mode.
3. Fill water in the wash tub to
the “L1” lower water level by
carefully adjusting the tap
water and add the detergent.
4. Put the cloths into the wash
tub and set the same water
pressure to fill the tub so as
not to exceed “H3” level.
5. Set the WASH TIMER
1-15 minutes.
6. After washing, set the
CYCLE SELECTOR KNOB
to “DRAIN”
7. Set the DRAIN/SPIN
TIMER for drain “H” for drain
(In case of need more drain)
❖ Please adjust the drain time
like H, M, L depend on the warer level.
H : High water level.
M : Medium water lever level.
L : Low water level.
12
4
35
