Machine settings
Setting Implementation
BUZZER permanent off
1. Turn the programme selector to any programme.
2.
Press simultaneously the DRYNESS Trocken-
grad and RPM U/Min buttons and hold down for
approx. 5 seconds.
3. The buzzer is by default always off. You can use
BUZZER option to activate or deactivate sound
but machine does not memorize your selection.
Water hardness
Water contains, a variable quantity of lime-
stone and mineral salts of which quantities
vary according to geographical locations
thus varying its conductivity values.
Relevant variations of the conductivity of
the water compared to those prefixed by the
factory could slightly influence the residual
humidity of the laundry at the end of the
cycle. Your dryer allows you to regulate the
sensitivity of the drying sensor based on
conductivity values of the water.
1. Turn the programme selector to any programme.
2.
Press simultaneously the DRYNESS Trocken-
grad and TIME Zeitwahl buttons and hold down
for approx. 5 seconds. The current setting is on
the display:
–
low conductivity <300 micro S/cm
–
medium conductivity 300-600 mi-
cro S/cm
–
high conductivity >600 micro S/cm
3. Press the Start/Pause button sequentially until
you set desired level.
4. To memorize setting press simultaneously the
DRYNESS Trockengrad and TIME Zeitwahl but-
tons or turn knob to OFF Aus position
Emptying water tank - warning message
permanent off
When using an external drain for the con-
densed water.
1. Turn the programme selector to any programme.
2.
Press simultaneously the RPM U/Min and TIME
Zeitwahl buttons and hold down for approx. 5
seconds.
The current setting is on the display:
–
warning
icon and - warning mes-
sage is off
–
warning
icon and - warning mes-
sage is switched on
By default the warning message is switched on and
displayed always at the end of the drying cycle or
during the cycle if the water container is full.
32
Machine settings
