Section 1 Basic Printer Functions 1-21
1. 8. 4 Environmental Condition - Correction
Take the necessary actions according to the environmental condition as shown below.
Humidity(%)
Possible problem Necessary treatment
“Void of image”, “crease of paper”
and other problems occurs when you
print.
1. Install a humidifier in the room, and
humidify the air.
2. Remove the media from the machine
immediately after the printing, and keep it
in a polyethylene bag.
“Void of image” occurs when you
print with vellum.
When not using it, remove the vellum from
the machine and keep it in a polyethylene
bag.
Remove the paper from the machine after
everyday use, and keep it in a polyethylene
bag.
“Void of image” occurs when you
print with plain paper and vellum.
When not using it, remove the media from
the machine and keep it in a polyethylene
bag.
Low
40%
70%
High
“Void of image”, “crease of paper”
and other problems occurs when you
print
1. Turn on the Dehumidify Heater.
2. Remove the media from the machine
immediately after the completion of print,
and keep it in a polyethylene bag.
NOTE
(1) KIP5000 is equipped with a Dehumidify Heater.
Using it in high humidity environment (65% or higher) is recommended.
(2) “Voids” and “creasing” will occur in case of extremely high or low humidity.
Normal Print
Normal Print
If the media is humidified
If the media is humidified
Crease
Void
