8
installed will determine the maximum length of the label.
Default Values:
A value must be entered or the command is ignored
101.6mm(4.00inch) using 8 dot/mm printhead
Comments:
If multiple ^LL commands are issued in the same label format, the last ^LL command will also
affect the next label unless it is prior to the first ^FS.
^ML
Maximum Label Length
Description:
The ^ML command lets you adjust the maximum label length.
Format: ^MLa
Parameters:
a = maximum label length(in dot rows)
Accepted Values: 0 to maximum length of label
Default Value: last permanently saved value
Comments:
In order for calibration to work properly, you must set the maximum label length equal to or greater
than your actual label length.
^LS
Label Shift
Description:
The ^LS command is used to shift all field positions to the left.
If the print position is less than 0,set ^LS to 0.
This command must come before the first ^FS command. Once you have issued an ^LS command,
the setting is retained until you turn off the printer or send a new ^LS command to the printer.
But if you execute “Save Setting” on operation-panel, the setting isn’t saved.
Format: ^LSa
Parameters:
a = shift left value(in dots)
