23
Use and Care Manual
Before You Call for Service
Problem May Be Caused By What to Do
Spotting and lming (cont.) Spray arms do not rotate
properly
Make sure that both spray arms rotate
freely. Make sure that items do not obstruct
movement of spray arms. If necessary, clear
any obstructions.
Make sure holes in spray arms are not
blocked. If necessary, clear holes with a
pointed object and rinse under water.
Strainer blocked Check strainer. Clean if necessary.
Excessive foam in the machine Use only “dishwasher” detergent.
Too much rinse aid in nal rinse cycle.
Adjust rinse aid dispenser (see page 13).
Flatware incorrectly loaded Make sure items are not nested (see page
9).
Clean-ability (Small par-
ticles deposited on items)
Spray arms do not rotate
properly
Make sure that both spray arms rotate
freely. Make sure that items do not obstruct
movement of spray arms. If necessary, clear
any obstructions.
Make sure holes in spray arms are not
blocked. If necessary, clear holes with a
pointed object and rinse under water.
Incorrect detergent use Use only correct amount of dishwasher
detergent according to water hardness (see
page 12) and the wash program selected.
Fill dispenser only when ready to start the
dishwasher. Do not use old or caked deter-
gent. Store dishwasher detergent in dry
place and in a closed container. Change the
dishwasher detergent if results are still poor.
Filter system Make sure lter system is clean and prop-
erly installed.
Low water pressure Check that water valve is fully open. Make
sure water pressure is between 20 and
120psi and ow rate is 1.0 gpm minimum.
Detergent left in detergent
compartment (Detergent
compartment will not open)
Dispenser lid blocked The lid may not be opening. Check for items
blocking it.
Old detergent Do not use detergent that is hard or caked
in the box. Use only fresh detergent. Add
detergent to dishwasher just before starting
it.
Spray arms do not rotate
properly
Make sure that both spray arms rotate
freely. Make sure that items do not obstruct
movement of spray arms. If necessary, clear
any obstructions.
Make sure holes in spray arms are not
blocked. If necessary, clear holes with a
pointed object and rinse under water.
