Problem Solution Guide (Continued)
Chipping or breaking
of glassware
Unusual noise
Water left in bottom
of dishwasher near
filters
Improper loading
Improper loading
Dish washing cycle not
complete
CANCEL button pressed
twice in middle of cycle.
Some water is normal
Do not overload. Load between rack prongs, not over
them. Glasses loaded over prongs will not be sup-
ported and may chip or break. Make sure glassware is
secure and can't come loose. Always use the top rack
for delicate items. Use the crystal cycle for china.
Utensils may not be secure or something small may
have dropped from the rack. Water may cause utensils
to rattle. Make sure dish-ware is secure.
Allow dishwasher to complete cycle.
Restart (page 15) or drain (page 17) dishwasher.
Water left in strainer is normal.
Dishwasher will not Air gap plugged Be sure the air gap is not blocked or plugged. The air
drain gap is a vent located on top of the sink. It is connected
to the dishwasher. It is required by some local codes.
Drain hose Check for kink in drain hose.
Filter system Be sure there is no blockage in filter system.
Dishwasher will not Blown fuse or tripped cir- Replace fuse or reset circuit breaker. Remove other
start cuit breaker appliances from the circuit.
Door not completely closed Push in on door handle until you hear a click.
Not plugged in incorrectly Make sure plug is inserted in the wall socket or dish-
washer is wired correctly.
Dishwasher will not Door not completely closed Push in on door handle until you hear a click.
fill Controls not se ....... Make sure dishwasher is on (see Page 14).
Water feed line blocked Make sure water feed line to dishwasher is not kinked.
No water supply Make sure water valve is turned on.
Water backs up in Garbage disposal or sink Run garbage disposal to eliminate food and obstruc-
sink when dish- trap full tions in sink. Make sure sink drains properly.
washer drains
Marks and discolor- Be sure aluminum utensils, especially light weight, foil-
ation type pans, do not touch dishes.
Yellow or brown
marks
Aluminum utensils rubbing
against items during wash
cycle
Iron or manganese in
water
To remove spots, use a non-abrasive cleaner,
Temporary solution"
Pour teaspoon to tablespoon of citric acid crystals
in place of the pre-wash detergent in the detergent
dispenser, Follow this pre-wash with a full detergent
wash, Use the heavy wash program ........
Permanent solution: Install an iron removal system in
the water Supply. .................................
Dishwasher
