Hardware Installation Card 6 of 7
in order to maintain uninterrupted service.
5. If the equipment is causing harm to the network, the
telephone company may request you to remove the
equipment from the network until the problem is
resolved. If so, contact Comtrol Corporation at 651-
631-7654.
6. No repairs are to be made by you. Repairs are to be
made only by Comtrol or its licensees. Unauthorized
repairs void the warranty and the registration.
7. This equipment may not be used for public coin phone
service provided by the Telephone Company.
Connection to Party Line Service is subject to state
tariffs. (Contact the state public utility commission,
public service commission, or corporation commission
for information.)
8. The Telephone Consumer Protection Act of 1991 makes
it unlawful for any person to use a computer or other
electronic device, including fax machines, to send any
message unless such message clearly contains in a
margin at the top or bottom of each transmitted page
or on the first page of the transmission, the date and
time it is sent, an identification of the business or other
entity, or other individual sending the message, and
the telephone number of the sending machine or of
such business, other entity, or individual. (The
telephone number provided may not be a 900 number
or any other number for which charges exceed local or
long-distance transmission charges.) In order to
program this information into your fax software, you
should refer to the manual of the Fax software being
used.
RocketModem - Canada
The RocketModem connects directly to off-premises
Common Carrier facilities using the standard two-wire
telephone connection. In some cases, the building’s inside
wiring associated with a single line individual server may
be extended by means of a certified connector assembly
(telephone extension card).
NOTICE: The Industry Canada label identifies certified
equipment. This certification means the equipment meets
telecommunications network protective, operational, and
safety requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements document(s).
The Department does not guarantee the equipment will
operate to the user’s satisfaction.
Before installing this equipment, users should ensure that
it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be
installed using an acceptable method of connection. The
customer should be aware that compliance with the above
conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be coordinated by a
representative designated by the supplier. Any repairs or
alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the
electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system, if
present, are connected together. This precaution may be
particularly important in rural areas.
CAUTION: Users should not attempt to make such
connections themselves, but should contact the appropriate
electric inspection authority or electrician, as appropriate.
NOTICE: The Ringer Equivalence Number (REN) assigned
to each terminal device provides an indication of the
maximum number of terminals allowed to be connected to a
telephone interface. The termination on an interface may
consist of any combination of devices, subject only to the
requirement that the sum of the Ringer Equivalence
Numbers of all the devices does not exceed 5.
This digital apparatus meets the Class B limits for radio
noise for digital apparatus set out in the interference-
causing equipment standard entitled: “Digital Apparatus,”
ICES-003 of Industry Canada.
When connecting the RocketModem to the telephone
service, avoid contact with the telecommunications lead
wire. Grasp the insulated part of the jack, and do not
contact the back of the circuit board. Telephone wiring can
carry dangerous voltages from electrical faults or
lightning.
External Wiring
Any external communications wiring you may install
needs to be constructed to all relevant electrical codes. In
the United States this is the National Electrical Code
Article 800. Contact a licensed electrician for details.
Canada - Return Center
In Canada, contact the following Return Center:
Gandacar Consulting, Ltd
189 Lake Avenue East
Carlton Place, Ontario
Canada K7C 1J7 Phone: 800-563-5102
