Witheachwashcycle.
Compartment
For pro gramm es with pre-wash only.
(Follow the user instr uctions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to f ill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt le vel
Load the baskets
Close the door, turn on the water tap and press the Start/reset button. The machine will start working
after about 10 seconds.
Running the dishwasher
Switch off the applia nce
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
The y will a lso dry better.Unload t he appliance, starting from the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt food in pa ns,
then l oad the baskets. Refer to the dishwashe r loading inst ructions.
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, the n stop.
Turn off the appliance using the ON /OFF button.
If the appliance is switched
off during a wash cycle.
Op en t he do or carefull y.
Hot st eam may esc ape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on agai n, plea se re-select th e washing cy cle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Press the On/Off button to switch on the applianc e, Open the door.
1.Open the door a little to stop the dishwas her.
2.After the spray arm s stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will star t running again after 10 sec onds.
For detailed operating method read the corresponding content on the instruction manual.
1. A running cycle can o nly be modified if it has been running for a short time. O therwise the detergent
m ay have alre ady be en released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Press the Start/Reset button for more than 3 second s to cancel the running programme.
3. Select a new programme.
4. Restart the dishwasher.
Select a programme
Turn the knob to select the desired programme
( S ee the secti on ent itle d Op era ti o ng in st ruct io n )“”
