ASSEMBLY INSTRUCTIONS
1. Open snow thrower carton.
2. A) Remove clutch rod
B) Remove cardboard insert 1, 2, & 3.
C) Remove bag of parts which is packed inside of insert #3.
D) Remove elbow & elbow insert.
E) Remove snow thrower.
1) Remove insert from underneath jackshaft pulley.
2) Remove last insert.
F) Open small carton.
1) Remove push rod, stack control and lift spring.
3. Remove belt guard from tractor.
4. Remove hex bolt and sleeve holding the front of the belt guard to the engine. Do not remove the
belt trapout. Remove bolt and rubber washers holding the rear of the belt guard to the frame.
Depress the Clutch-Brake Pedal and lock in the brake position (fully depressed pedal) with the
parking brake.
If your tractor was manufactured after 1968 eliminate step No. 5.
5. Loosen the bolt holding the spring tension idler and belt clip. Mark position of belt clip. Roll
belt off pulley TOWARDS the engine. Remove set screws (2) and pull off engine pulley. Refer to
Fig. 1. Replace bolt and two rubber washers in the frame.
BELT CLIP
