Owner’s Guide & Installation Instructions
83 / English
Troubleshooting
Problem Reason Solution
Load is still too
soapy / Machine
is full of suds
at the end of
program.
Not using HE detergent /
Using excessive amount of
detergent
* Do not unload the machine.
Operate a quick wash cycle
(e.g. Delicates, Wools)
without any detergent.
Add 1-2 tablespoon of
fabric softener into main
wash compartment of
detergent dispenser
during water intake.
Use proper amount of HE
detergent next time you
operate the machine.
Laundry remains
wet at the end of
the program. (*)
Excessive foam might have
occurred and automatic foam
absorption system might have
been activated due to too
much detergent.
* Use the recommended
amount of detergent.
Unbalance detection due to
small amount of laundry inside
the drum and/or uneven load
distribution.
* Add more laundry (e.g. a
few additional towels) to the
drum and start a “Spin” or
“Spin&Drain”cycle.
Poor spinning results due to
not using HE detergent / using
excessive amount of detergent
* Use proper amount of HE
detergent.
Washer fills with
water when
a process is
cancelled.
There may be hot water inside
washer.
* For safety reasons, water
should be cycled in and out
a couple times.
Time delay
function does
not work.
Door may not be closed
properly.
* Close the loading door.
The door will not
lock/door led
remains OFF.
Door is not properly closed/
Door hinge is not aligned with
lock switch.
* Check for excessive laundry
avoiding the door to be
closed.Pushand/orshutthe
loading door firmly until it is
properly closed.
