74 / English
Front-Loading Automatic Washer-Dryer
Troubleshooting
Problem Reason Solution
Product directly
discharges the
water it takes in.
Draining hose might not be at
an adequate height.
* Connect the water draining
hose as described in the
operation manual.
No water can be
seen in the drum
during washing.
Water is inside the invisible
part of the product.
* This is not a failure.
Loading door
cannot be
opened.
The cover lock is activated due
to the water level inside the
product.
* Drain the water by running
thePumporSpinprogram.
Washer might be heating up
the water or it may be at the
spinning cycle.
* Wait until the process is over.
Due to electrical safety
mechanism, the door can only
be opened a few minutes after
the program has stopped.
* Wait until the process is over.
Child lock is engaged. Door
lock will be deactivated a
couple of minutes after the
program has come to an end.
* Wait for a couple of minutes
for deactivation of the door
lock.
If the door can not be opened
after minimum ten minutes
the program has stopped ,
machine should be switched
off pressing on/off button.
* If the situation remains,
call the qualified service
technician.
