Optional System Accessories
WIRELESS ESSENTIALS
™
MICROPHONES AND CABLES
All Wireless Essentials accessories are terminated for use with ATW-T310
and other UniPak
™
transmitters.
AT829cW Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
MT830cW Miniature omnidirectional condenser lavalier
microphone. Includes clothing clip and windscreen.
MT830cW-TH “Theater” model, same as MT830cW except beige color
mic and cable for concealment.
A
T831cW Miniature cardioid condenser lavalier microphone.
Includes clothing clip and windscreen.
A
T851cW Surface-mount wide-range hemi-cardioid condenser
microphone.
A
T857AMLcW 19" gooseneck cardioid microphone.
Mounts to
5
/
8
"-27 thread. Includes windscreen.
AT889cW Headworn noise-canceling condenser microphone.
Includes windscreen and cable clip.
AT898cW Subminiature cardioid condenser lavalier microphone.
Includes clothing clip base, viper clip base, magnet clip base,
three single mic holders, two double mic holders and
two windscreens.
AT899cW Subminiature omnidirectional condenser lavalier microphone.
Includes AT899AK accessory kit.
AT899cW-TH “Theater” model, same as AT899cW except beige color mic
and cable concealment. Includes AT899AK-TH accessory kit.
ATM35cW Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
ATM73cW Headworn cardioid condenser microphone.
Includes windscreen.
ATM75cW Headworn cardioid condenser microphone.
Includes windscreen.
PRO 8HEcW Headworn hypercardioid dynamic microphone.
Includes windscreen and cable clip.
PRO 35xcW Cardioid condenser instrument microphone.
Includes AT8418 clip-on instrument mount.
AT-GCW Hi-Z instrument/guitar cable with
1
/
4
" phone plug.
XLRW Connecting cable for UniPak transmitter with an XLRF-type
input connector, for Lo-Z microphones with XLRM-type
output terminations.
RECEIVER ACCESSORIES
AEW-DA550C UHF (540–565 MHz) active unity-gain antenna distribution
system provides two “1-in, 4-out” RF channels; connects a
pair of antennas to as many as four diversity r
eceivers;
cascade output provided as a directional coupler. AC pass-
through allows daisy-chain AC hookup. Defeatable antenna
power. Metal receiver chassis with reinforced mounting ears
and rear rack mount capability. Includes detachable IEC
power cable, IEC pass-thr
ough cable, ten RF cables, front-
mount antenna cables and connectors, four DC power
cables to power up to four 3000 Series receivers. Mounts in
a single 19" rack space. For use with ATW-R310C (Band C)
receivers.
AEW-DA660D Same as AEW-DA550C except for 655-680 MHz operation.
For use with ATW-R310D (Band D) receivers.
AT8630 Joining-plate kit allows rack-mounting two ATW-R310
receivers side-by-side in a single (1U) 19" rack space.
ATW-A20 Pair of UHF ground-plane antennas with
5
/
8
"-27 thread for
mounting to microphone stands, etc. For use with
ATW-R310D (Band D) receivers. Takes RF cables with BNC
connectors, not included; see RF Cables below
.
ATW-A49 Pair of UHF wide-band directional LPDA (log periodic dipole
array) antennas provide enhanced signal pickup for UHF
wireless systems throughout a wide band range
(440-900 MHz). Each antenna paddle is matched to 50 ohms
impedance with intergral high-quality low-loss BNC
connector; 6 dB gain. For permanent or temporary
installation; mounts to
5
/
8
"-27 threads.
ATW-RA1 Rack-mount antenna kit brings antenna inputs to the front of
receiver for ease of setup, or when receiver is enclosed in a
metal rack. Includes a pair of extendible antennas. NOTE:
Two adapter kits are required when mounting two receivers
side-by-side in a single 19" rack space.
RF Cables Low-loss design, 50 ohm impedance, with BNC-to-BNC
connectors:
AC12 RG58-type cable (12')
AC25 RG8-type cable (25')
AC50 RG8-type cable (50')
AC100 RG8-type cable (100')
TRANSMITTER ACCESSORIES
AT8114 Foam windscreen for handheld transmitter.
AT8141 Water-resistant pouch for UniPak transmitter.
AT8390 Shielded audio cable with
1
/
4
" to
1
/
4
" phone plugs.
Available in a variety of lengths.
(Also available with one straight and one 90° phone plug
as the AT8316.)
A
T8456a
Quiet-Flex™ stand clamp for handheld transmitter
,
5
/
8
"-27 threads.
11
See pages 16-17 for illustrations.
