14
FAULT TRACING
The machine will not start
1. Is the door shut properly? Push it firmly. A
flashing symbol appears in the display if
the machine is started with the door open.
2. Is there power to the machine. Check the fuse
box.
3. Check if the child lock is activated. To start
the machine when the child lock is activated,
hold in the
Start/Stop
-button for 3 seconds. See
Changing settings.
Door will not open
1. Check that the power switch is on.
2. Has there been a power cut? Check the fuses
in the fuse box. The door cannot be opened
with the button if there is no power.
3. If everything else fails the door can be opened
in an emergency as follows:
• Make sure the power switch is off.
• Machines with a drain pump: First check that
there is no water left in the machine. If there
is, empty the machine as described under the
heading Checking trap and drain pump, in
the chapter on Cleaning and Maintenance.
• Open the flap at the bottom left. Use a screw-
driver as shown.
• Unscrew the screw that holds the red plastic
handle.
• Pull the handle to open the door.
• Press the handle back into its recess and secu-
re it with the screw. Close the flap.
If you have problems opening the door normally
again, call service.
The machine will not work
1. Measure the voltage between E1-1 and E1-2.
The value should be the same as the mains
power supply voltage.
2. Check the machine and house fuses. If neces-
sary change the fuses and investigate why they
have blown.
3. Check the main power switch.
4. Check the door switch.
The washing lid is difficult to close or will
not close
1. Check the door switch, it may be faulty.
2. Check that the lid seal is located correctly.
The washing lid leaks
1. Clean the lid seal.
2. Mount an O-ring front door (Art. no: 80 641
78). O-ring front door has been added on
machines produced after week 18 2000. The
O-ring front door can be mounted on earlier
produced machines when it´s a leakage from
the lid.
Mount as follows:
Mount the O-ring by putting it on the outsi-
de of the seal, between the inner plastic part
of the front panel and the seal.
3. Check and if necessary change the lid seal.
The machine does not perform washing
rotation or does not reverse the direction of
washing rotation
1. Check that the drive belt is located correctly.
2. Check and repair or change the motor con-
trol board , see the electrical schematic dia-
grams to find the measuring points.
3. Check or change the motor.
4. Check the level switch.
The drum turns slowly during washing rota-
tion
1. Check that the drive belt is tight and that the
adjustment screw for motor suspension is scre-
wed tight.
FAULT TRACING
