3
the red voltage switch setting on the power supply. It should match your local voltage (115V
for North America, Japan, etc. and 230V for Europe and many other countries). If it doesn't
match, please change the setting. If you don't, you could damage your equipment and void
your warranty.
3. Remove the thumbscrews from the panel with the latch. Unlock the side panel, swing the panel
out, and remove it. Set the panel safely aside. Note: Please don't try to use your fingernails to
pry or lift the panel.
4. Inside the case you should see the power supply, the 120mm TriCool fan preinstalled, the
Antec Chassis Air Guide (ACAG), some wiring with marked connectors (USB, PWR etc.), and
installed I/O panel, a power cord. You will also find a bag of hardware (screws, brass
standoffs, plastic stands, etc.)
5. Lay the case down with the open side facing up. You need to remove the Antec Chassis Air
Guide (ACAG) before your motherboard installation. To remove the ACAG:
6. Remove the two screws and loosen the thumbscrew found at the bottom of the ACAG. (picture 1)
7. Loosen the thumbscrew near the 120mm fan grill, that is holding the ACAG to the chassis.
(picture 2).
8. Loosen the thumbscrew at the top of the ACAG under the power supply. (picture 3)
9. With both your hands holding the ACAG, slowly slide the ACAG toward the front of the case
until it stops.
10. Raise the top of the ACAG and slide the ACAG out from its position. You will see a Tube
remaining in the chassis. You can leave the tube in the case.
11. If you want to remove the tube, slide the tube towards the top of the case. Pull the tube away
and put the tube aside.
two screws thumbscrews
