Technical Specifications
DIMENSIONS Height
Width
Depth
850 mm
400 mm
600 mm
LINE VOLTAGE /FREQUENCY
POWER CONSUMPTION
230 V / 50 Hz
2300 W
WATER PRESSURE Minimum
Maximum
0,05 MPa (0,5 bar)
0,8 MPa (8 bar)
Connection to water supply Type 20/27
Installation
Remove all protective packaging for transit before
using for the first time. Keep in case needed for
future transit: Transporting a non-secured appli-
ance may damage internal components and cause
leakages and malfunctions. The appliance can al-
so be damaged through physical contact.
Unpacking
1
2
3
5
6
7
8
4
Untying
4
1
2
3
5
1
3
4 5
2
To install your washing machine at the same level
as surrounding furniture, proceed as shown on
picture 5.
Water supply
Install the supplied water inlet hose at the rear of
your washing machine by proceeding as follows
(Do not reuse an old hose):
1 2 3 4
Open the water inlet tap. Check there are no leaks.
The water inlet hose can not be extended. If it is
too short, please contact the after-sales service.
Drainage
The connector at the end of the flexible hose can
be attached to all common types of standpipe. At-
tach the connector to the standpipe with the hose
clamp supplied with the appliance
4)
Fit the U-piece on the drainage hose. Place every-
thing in a drainage point (or in a sink) at a height of
between 70 and 100 cm. Ensure it is positioned
securely. Air must be able to enter the end of the
hose, to avoid any risk of siphoning.
Warning!
The drain hose must never be stretched. If it is too
short, contact an engineer.
Electrical connection
This washing machine must only be connected in
single-phased 230 V. Check the fuse size: 13 A for
4) depending on the model
electrolux 17
