Operating Manual 3
System Description and Operation
The Solarc Light Source is used to supply high-quality, white light
for video and optical illumination systems.
1. Plug the power supply into a grounded AC receptacle. The
power switch should be in the OFF position .
If your So
larc Light Source has the light intensity control
option, turn it to the minimum position (Figure 1). Plug the
fiber optic bundle into the light port and connect the opposite
end to the equipment being used.
2. Turn the power switch to the ON position .
If your So
larc Light Source has the light intensity control
option, set the light intensity to the desired level (Figure 1).
3. Turn unit OFF when not in use.
Figure 1. Front and Back View
Lamp Replacement
Caution Do not restart the Solarc Light Source immediately after shutting it
off - it may fail to light. If this occurs, turn the power off and wait 10 to 15
seconds before turning the unit back on.
Power Switch
Maximum
Minimum
Light
Control
Power Input
Fan
WARNING RISK OF SHOCK. Do not operate the Solarc
Light Source without a lamp installed. Disconnect power
before attempting to change lamp.
