Water inlet
Caution!
• This appliance must be connected
to a cold water supply.
• Before connecting up the appliance to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected.
• Do not use the hose from your previous
appliance to connect to water supply.
The inlet hose is supplied with the appliance
and can be found inside the machine drum.
35°
45°
Open the porthole and extract the inlet hose.
Connect the appropriate end of the hose to
the appliance with the angled connection as
showed in the picture. Do not place the in-
let hose downwards. Angle the hose to the
left or right depending on the position of your
water tap.
After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks .
Connect the other
end of the inlet hose
to a tap with a 3/4”
thread. Always use
the hose supplied
with the appliance.
Caution! The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase
a new, longer hose specially designed for this
type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the
edge of a sink us-
ing the plastic
hose guide.
In this case, make sure the end cannot come
unhooked when the machine is emptying. This
could be done by tying it to the tap with a
piece of string or attaching it to the wall.
In a sink drain pipe branch. This branch
must be above the trap so that the bend is at
least 60 cm above the ground.
Directly into a drain pipe at a height of
not less than 60 cm and not more than 90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside di-
ameter of the drain hose. The drain hose must
not be kinked.
Building in
This appliance has been designed to be built in-
to the kitchen furniture. The recess should have
the dimensions shown in picture A.
21
www.zanussi.com
