
Using the PFM R33 / R36 Receiver
IMPORTANT: If Alkaline (nonrechargeable) batteries are being installed, slide the battery selection
switch in the battery compartment to the “Alkaline” position. See FIG 5 below. If installing NiMH (or
rechargeable) batteries, slide the battery selection switch to the “NiMH” position.
1. Install two (2) AA batteries. Note: rechargeable batteries must be charged before use. See Battery
Information on page 11.
2. (Applies only to PFM R36) Insert the small plug mount microphone (MIC 014) into the “Mic Jack”
( ) on the top of the receiver. See FIG 7 below. Note: The MIC 014 cannot be used with the transmitter.
3. Plug the earphone or headphone into the “Headphone Jack” ( ) on top of the receiver. See FIG 6 / FIG 7.
Place the headphones on your head or earphone in your ear.
4. Turn the power on by rotating the “On/Off/FM Volume” knob clockwise. The “Power On Indicator” ( )
should illuminate green.
5. Select the desired operating frequency. Locate the “Channel Selector” inside the battery door (See FIG.
5). Use the supplied small screwdriver to rotate the switch to the desired channel (See FIG. 9, Page 10:
Channel Selection Chart).
FIG. 5: Battery Selection Switch /
ConFIGuration Controls
1 2 3
1. Tone Control 2. Channel Selector 3. Max Gain Control
Battery Selection Switch
FIG. 6: PFM R33 Top View FIG. 7: PFM R36 Top View
7