Dipole Antenna (ANT 016) Installation
The WMS L150 Liberator One System includes the ANT 016 Dipole
Antenna. Assemble the antenna as shown on the previous page. Use
the Coaxial Feedline Cable included to connect the Dipole Antenna to
the Antenna Connector on the rear panel of the WMS R11 Receiver.
The Dipole Antenna is designed to be mounted on a wall. Be sure to
use proper fasteners (wall anchors, screws). For proper performance,
the Coaxial Feedline Cable
MUST exit the antenna at a right angle, as
shown, for at least 12" before bending the cable.
ANT 016
Dipole Antenna
Cable Routing,
Front View
Coax should exit
antenna at right
angle as shown
Cable Clamps - 12" apart
13
