6
Installation
Remove the transport bolts
1.
Slacken the four bolts with
the spanner supplied.
2.
Remove by hand.
3.
Grip the bolt and remove it
through the large aperture.
4.
Seal the resulting holes
using the plastic caps
supplied; insert the covers in
the wide part of the hole
and slide them toward the
narrow part until they click
into place.
5.
Retain transit bolts.
Secure the washing
machine before
transporting it:
1.
Pry off the plastic covers
with a screwdriver, slide
them in the opposite
direction of the arrow and
remove.
2.
Refit the transit bolts in
reverse order.
Adjusting the feet
Small unevennesses in the floor
can be compensated for by
screwing the four appliance feet
up or down (never use pieces of
wood, cardboard or similar
material):
1.
Loosen the locknut using the
wrench provided.
2.
Adjust the height of the foot
by hand.
3.
Tighten the locknut
anticlockwise towards the
washing machine.
If the appliance is to be installed
on a wooden floor, place it on a
sheet of plywood at least
60x60 cm in size and 3 cm thick.
Secure the plywood sheet to the
floor.
