19
The water is not pumped
out of the washing
machine.
The notice “FP” appears in the
display.
Switch the appliance off and pull
out the mains plug.
Check whether:
•
the drain hose is kinked
•
the pump or the filter is
blocked (see “Removing The
Filter”)
IMPORTANT:
Before emptying
ensure that the water has
cooled down.
•
the water in the drain hose is
frozen up
Reconnect the appliance to the
electrical socket.
Switch the washing machine on
again, select a programme and
start the appliance. To rinse the
laundry, we recommend a short
programme without the
addition of detergent.
If the fault occurs again, please
contact After-Sales Service (see
“After-Sales Service”).
There is a fault in an
electrical component.
A notice from “F4” to “F16”
appears in the display.
•
press the “Reset
” button and
start the programme again
with the “Start/Pause” button
•
if the fault occurs again, please
contact After-Sales Service (see
“After-Sales Service”)
There is a fault in the
“Water Stop”.
The message “Excessive Foam!”
or “FA
” appears on the display
and the pump operates.
The “Water Stop” fault may have
been triggered by:
1.
excess foaming;
2.
a leak in the washing
machine.
In this case the pump is switched
on automatically in order to
pump the water out.
Switch the appliance off, pull out
the mains plug and turn the
water tap off. Tilt the appliance
forwards carefully to allow the
collected water to drain out of
the appliance base.
Then:
1.
Reinsert the mains plug in the
socket.
2.
Turn the water tap on (if
water immediately flows into
the appliance again, without
the appliance being started,
there is a fault. Turn the tap
off and notify After-Sales
Service, see “After-Sales
Service”).
3.
Switch the washing machine
on again, select the desired
programme and start the
appliance.
If the fault occurs again, please
contact After-Sales Service (see
“After-Sales Service”).
