GB 11
Description of red indications
Red indication lights up
Description
Possible causes
Solutions
“Water tap closed”
Appliance has no or insufficient water supply. The
“Start/Pause”
light
flashes.
Check whether:
•
Water tap is fully open and water supply pressure is sufficient.
•
Kinks are present in the water inlet hose.
•
Mesh filter of water supply hose is blocked (see “Care And
Maintenance”.
•
The water hose is frozen up.
•
The safety valve inspection window of your water supply hose is red
(provided your appliance has a water supply hose as shown on picture
“B”
- see previous chapter “Care And Maintenance”); replace the hose
by a new one available through our After-Sales Service or your specialist
dealer.
After problem has been removed, restart programme by pressing
“Start/
Pause”
. If the fault occurs again, contact our After-Sales Service (see next
chapter).
“Clean pump”
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
•
Kinks are present in the drain hose.
•
Filter or pump is blocked (see chapter “Removing The Filter”;
make
sure the water has cooled before draining the appliance).
•
The drain hose is frozen up.
After problem has been removed, select and start the “Drain” programme
or push the “Reset” button for at least 3 seconds; afterwards restart the
desired programme. If the fault occurs again, contact our After-Sales-
Service (see next chapter).
40110021GB.fm Page 11 Wednesday, May 2, 2007 10:13 AM
Black process 45.0° 100.0 LPI
