GB 12
Red indication
lights up
Indication on big
display
(if available on your
model)
Description
Causes
Solutions
“Service”
from “F02” to “F35”
(except “F24”)
“Electrical module fault”
Push the “Reset” button for at least 3 seconds.
from “F40” to “F43” “Electrical module fault”
Make sure that the water tap is open. If yes:
•
Switch the washing machine off by turning the
programme selector to the “Off/O” position; then
turn the programme selector to a wash
programme again. If there is still a failure:
•
Push the “Reset” button for at least 3 seconds.
“F24” “Water level too high” (after programme
cancellation or false operating). Switch off the
washing machine by turning the programme selector
to the “Off/O” position. Turn the programme
selector to a wash programme again, shortly press
the “Reset/Drain” button and press
“Start /Pause”
within 15 seconds to start the Drain programme.
“F02” or “FA” “Waterstop fault”
For models with big display, the red “Waterstop”
symbol will also light up in this case.
Turn the programme selector to the “Off/O”
position, pull out the mains plug and turn the water
tap off. Tilt the appliance forward carefully to allow
collected water to flow out from the bottom. Then:
•
Plug in the appliance again.
•
Turn the water tap on (if water immediately flows
into the appliance without the appliance being
started, there is a failure; turn off the tap and notify
the After-Sales Service).
•
Select and start the desired programme again.
“Fod” “Overfoaming”
Too much foam interrupted the wash programme.
•
Select and start the “Rinse & Spin” programme.
•
Afterwards select and start the desired
programme again, using less detergent.
If any of the faults described above persist,
unplug the appliance, turn off the water tap
and contact our After-Sales Service (see next
chapter).
