GB 5
Where to put detergent and additives
The detergent drawer has three chambers (fig. “
A
”).
Prewash Chamber
•
Detergent for the prewash
Main Wash Chamber
•
Detergent for the main wash
•
Stain remover
•
Water softener
Softener Chamber
•
Fabric softener
•
Liquid starch
Pour additives only up to the “MAX” mark.
If you use liquid detergent, close the dispenser
right after having
filled in the detergent
.
Using chlorine bleach
•
Wash your laundry in the desired programme (Cotton, Synthetics),
adding an appropriate amount of chlorine bleach to the SOFTENER
chamber (close the detergent dispenser carefully).
•
Immediately after end of programme, start the “Rinse and Spin”
programme to eliminate any residual bleach smell; if you want,
you can add softener.
Never put both chlorine bleach and softener into the softener
chamber at the same time.
•
Prefer to use bleaches on oxygen basis; in this case follow the
instructions of the manufacturer.
Using starch
•
Select the “Rinse and Spin” programme and check that the spin
speed is adjusted to not more than 800 rpm.
•
Start the programme, pull out the detergent dispenser so that you
can see approximately 3 cm of the softener chamber.
•
Pour the starch solution prepared into the softener chamber
while the water is running into the detergent dispenser.
Cleaning the detergent dispenser
We recommend that you check and clean the detergent
dispenser regularly.
1.
Pull out the dispenser drawer until it stops. Press with your finger
on the space of the siphon being marked with “PUSH” (fig. “
B
”)
to release the drawer and pull it out completely.
2.
Remove the siphon from the softener chamber by pulling it
upwards (fig. “
C
”).
3.
Wash all the parts under running water.
4.
Clean the dispenser compartment with a damp cloth.
5.
Refit the siphon in the softener chamber by pushing it down until
it stops; then push the dispenser drawer back into the dispenser
compartment.
C
B
PUSH
