117
WHEN TO DRAIN RESIDUAL WATER
•
If the filter needs to be cleaned during a
programme.
Note:
Make sure that the water has cooled
before draining.
•
When transporting or moving the machine.
•
If there is danger of freezing in the installation
room. In this case the machine and the hoses
should be drained after every wash.
DRAINING RESIDUAL WATER
1.
Switch off the appliance.
2.
Unplug the machine from the mains.
3.
Unclip the drain hose connection on the rear
part of the machine (see arrow
A
and
B
).
4.
Place a container in suitable size beside the
machine.
Note:
After a correct draining cycle the residual
water amounts about up to 1 litre but there can
be up to 20 litres of water in the machine if
stopped during a programme and even 40 litres
if the pump is blocked.
5.
Lower the drain hose into a container and let
the water drain.
Note:
Make sure that the water has cooled
before draining.
6.
Wait until the flow stops.
7.
Fix again the drain hose on the rear side of the
machine (see arrow
B
) otherwise there is the
risk of leakage and the normal filling and
draining functions of the machine cannot be
guaranteed.
8.
Replace the drain hose with the “U” bend and
fix it.
Drain residual water from the machine, and
the inlet hose after every wash cycle.
1.
Switch off the appliance.
2.
Unplug the machine from the mains.
3.
Close the tap, loosen the inlet hose from the
machine and let the water drain out.
4.
Open the filter, let the water drain out and
close it again.
Note:
Before a new wash cycle screw the inlet
hose to the machine by hand. Check water-
tightness of washing machine connections by
turning the tap completely on.
DRAINING RESIDUAL WATER
WASHING MACHINE INSTALLED IN ROOM
EXPOSED TO FREEZING TEMPERATURES
