73
PROGRAMME SELECTION
Preparation of wash cycle
1.
Load the machine, close the drum flaps and check that they are properly locked.
2.
Add detergents and additives into the dispenser to no more than the
MAX
level mark. Please refer
to Detergents and additives.
3.
Turn the
programme selector knob
to the desired programme.
4.
Turn the temperature selector knob (if available) to the desired temperature.
5.
Turn the spin speed selector knob to the desired spin speed. If the spin speed 0 is selected, the
final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle.
6.
Select the desired options as described in the Programme Chart.
Programme start
Turn on the tap and press the
On/Off
button. The indicator light of the
On/Off
button lights up.
Note
: If there is a power interruption or if the washing machine is disconnected during the cycle, the
programme will run again from the point where it was interrupted.
End of wash cycle
The programme selector knob is in the Stop position .
1.
Press the
On/Off
button to switch off the machine.
2.
Cancel the options.
3.
Turn the tap off.
4.
Wait for the lid to unlock (about 1 minute).
5.
Open the lid and the drum flaps and unload the machine.
Change the programme during the wash cycle
1.
Switch off the machine by pressing the
On/Off
button.
2.
Select the new programme.
3.
Start programme by pressing the
On/Off
button again.
Pause/Interrupt a programme
If, for any reason, you wish to interrupt the programme for a certain time and continue it later:
1.
Press the
On/Off
button.
2.
After the desired pause, press the
On/Off
button again.
Cancel programme
1.
Switch off the machine by pressing the
On/Off
button.
2.
Set the programme selector to Drain.
3.
Press the
On/Off
button again to start the Drain programme.
