14
ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
First of all.
Turn on the water tap completely
and press ON-OFF button "A".
indicator light "B" comes on. Now
the appliance is on and ready to be
programmed.
Selecting the wash
cycle.
To select the wash cycle, turn knob
"D" clockwise until the reference
notch on the knob is aligned with
the symbol or number of the wash
cycle (have a look at the wash
cycle table on page 16).After a
few seconds, you will hear a short
beep and the indicator light G
comes on, indicating that the wash
cycle has begun and it is not
advisable to make any changes at
this point.
The dishwasher informs
you.
Your dishwasher is provided with
indicator lights (G) which come on
as the appliance carries out the
wash phase indicated by the
indicator light.
Starting from the indicator light on
the left moving towards the one on
the right: pre-wash, wash, rinses,
drying.
At all times, your dishwasher tells
you where it is at.
Modifying a wash cycle in
progress.
But if you have chosen the wrong
cycle, not to worry! You can modify
the wash cycle in progress, if it has
only just started. Turn the knob
anti-clockwise and set it to Reset,
after a few seconds you will hear 4
beeps and indicator light "G" will
go out: this means all the settings
have been cancelled. You are now
free to re-set the correct wash cy-
cle.
You've left out a dish?
Well,it happens to everyone.
Interrupt thewash cycle by
pressing the ON-OFF button, insert
the dish you had forgotten and
press the ON-OFF button again.
The cycle will start up from where
you interrupted it.
Finished?
The end of the wash cycle is sig-
nalled by 2 short beeps and a flash-
ing drying phase indicator light
G. Set the knob to the Reset
position to clear all settings.
Turn the appliance off by pressing
button "A", thus cutting off the elec-
tricity supply.
Turn off the water tap.
Wait a few minutes before unload-
ing the dishes: they are very hot! If
you wait a little while, they dry
better thanks to the steam.
Empty the lower rack first.
Ready, steady, go!
You have loaded your dishes and you now have
to set the wash cycle. It takes just one minute
to learn how
Starting the dishwasher
You can cancel
the wash cycle in
progress, if it
has only just
started.
Make sure the
wash cycle has
ended before
removing the
dishes!
If opening the
door soon after
the end of the
programme,or
during it, stand
away from the
Dishwasher, to
avoid possible
injury from hot
steam.
There's been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and then
restarts when the electricity comes
back on or when you close the door.
Everything is under control!
