Before using the dishwasher/Connections
1. Removing the packaging
and controls:
After unpacking, make sure
that the dishwasher is
undamaged and that the
door closes correctly. If in
doubt, contact a qualified
technician or your local
retailer.
• Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out
of reach of children, as they
are potentially dangerous.
• This dishwasher has been
factory tested to ensure it
functions correctly.
Such testing may leave
slight water marks that will
disappear with the first
wash.
2. Water and electrical
connections:
All water and electrical
connections must be carried
out by a qualified
technician in compliance
with the manufacturer's
instructions (refer to the
enclosed installation
booklet) and current local
safety regulations.
The appliance must only be
used in the household for
the prescribed uses.
Do not use the dishwasher if
it has been damaged in
transit. Consult your local
retailer or our After-Sales
Service.
(Refer to the separate
installation instructions
booklet)
3. Water inlet and drain:
• Observe any special
regulations issued by your
local Water Board.
Water supply pressure:
0.3 - 10 bar.
• Make sure the inlet and
drain hoses are kink-free
and are not crushed.
• If the hose length is not
sufficient, please contact
your local dealer or our
After-Sales Service.
• The inlet hose must be
securely clamped to the
water tap to prevent leaks.
• The inlet water
temperature varies
according to the model
installed. Inlet hose marked
“25° C Max”: maximum
temperature 25° C.
All other models: maximum
temperature 60° C.
• When installing the
appliance, make sure the
drain water discharges
correctly (if necessary,
remove the wire gauze
from the sink siphon).
• Fix the drain hose to the
spigot with a clamp to
prevent it from coming off
during operation.
For appliances with water-
stop system only: If the water
connections are made
correctly, the water-stop
system safeguards your
home against damage
caused by flooding.
4. Electrical connection:
• Closely adhere to local
Electricity Board
regulations.
• Voltage information is
shown on the rating plate
mounted inside the door on
the right hand side.
• The appliance must be
earthed as prescribed by law.
• Do not use extension leads
or multiple adapters.
• Before carrying out
maintenance, disconnect
the mains plug.
• If necessary, the power
cable may be replaced with
one the same obtained
from our After-Sales
Service. The power cable
must only be replaced by a
qualified technician.
Warning for models
provided with LCD
display:
The mains plug must be
positioned in an easily
accessible place.
• For Austria: if the
apparatus is series
connected to a fault current
switch, this must be
sensitive to the pulsating
current.
4gb94056.fm Page 2 Thursday, October 10, 2002 4:19 PM
