Page 7 of 9
Premium Tech Tool
Information is subject to change at any time without notice. Any printed copy of this bulletin is an uncontrolled document.
If a fleet purchases Tech Tool 2 with programming capability, what
should they
expect to be able to program
They can program the ECM, ACM and VECU for OBD2013 and newer vehicles.
You
can also make changes to parameters.
Why doesn’t Tech Tool 2 automatically identify Mack V-MAC III?
Tech Tool 2 does not automatically identify Mack legacy vehicles. You must
manually select the vehicle Make and Model. Look for improvements in the
near future.
Why did we change to the new VoCom adapter?
This new adapter is more rugged and suited to the workshop environment.
The
cables are also more suited to the workshop and should last a long time. The
VoCom supports three data-links at the same time. This is needed to fully
support
the OBD2013 vehicles.
Can we use the 88890020 communications interface on the OBD2013
trucks with
the 16 pin Diagnostic connector?
Yes and no. There is a 16 pin cable, 88890026 that you can use with the
88890020 interface but this combination can only support two data-links at a
time. This will support ISO and J1587. J1939 is not supported with this cable.
Does Tech Tool 2 work with different brands of communication adapters?
Yes, Tech Tool 2 works with some RP1210 adapters.
Check http://volvotrucksemedia.com/Default.aspx and http://www.macktrucksemedia.com
for a complete list.
Is there a 16 pin cable for the Dearborn interface? P/N: DG-V13-cable-kit
Yes, please visit www.dgtech.com
Is there a 16 pin cable for the Noregon interface? P/N: 12159
Yes, please visit www.noregon.com
Is there a 16 pin cable for the Nexiq USB interface?
Yes, Nexiq P/N: 442023 make sure you update the drivers to the latest version.
They are available at www.Nexiq.com. The current version is: V9.2.1.0.
