User instructions
17
To annul the program
• press the START/PAUSE button (3 ) for a few seconds; the light of
the phase in progress remains on and the light of the program in
progress flashes (confirmation beep);
• Keep the START/PAUSE button (3) pressed until the PROGRAM
PHASES lights (5) go out (confirmation beep). “
P0
” will appear
on the DISPLAY and pump-out of the water in the tank will begin,
ending the program at the point where it was interrupted. When the
operation is complete, the PHASES/PROGRAM LIGHTS (5) flash.
The water in the tank will be pumped out and the program will end at the
point where it was interrupted. When the operation is complete, the
PROGRAM PHASES lights (5) flash.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph “
S
TARTING THE PROGRAM”. The program will resume from the
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 60 seconds later.
Options are selected by pressing the relative button by the symbol of the
option required; the light comes on to confirm that the option has been
activated.
• It is not possible to select any options when the soak
program is being used.
• All options except "Flexi Tabs" are disabled at the end of the
wash cycle. To disable the “Flexi Tabs” option, press the
relative button (the light goes out).
• All options, including "Flexi Tabs" are disabled when a
program is CANCELLED after it has begun.
Select this option together with any washing program (except the soak
program) to SHORTEN the cycle by from a minimum of 10% to a
maximum of 55%, depending on the cycle selected. To activate this
option, press the QUICK OPTION button (light comes on) after
selecting the program required. The option is automatically deactivated
at the end of the program.
