Once you have checked the appliance, press . If the
problem occurs again, contact the Service.
For alarm codes not described in the table, contact the
Service.
The washing and drying results are not satisfactory
Problem Possible solution
There are whitish streaks or bluish lay-
ers on glasses and dishes.
• The release quantity of rinse aid is too much. Adjust the rinse aid selec-
tor to a lower position.
• The quantity of detergent is too much.
There are stains and dry water drops
on glasses and dishes.
• The released quantity of rinse aid is not sufficient. Adjust the rinse aid
selector to a higher position.
• The quality of the rinse aid can be the cause.
The dishes are wet.
• The program does not have a drying phase or has a drying phase with
low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• Keep the dishwasher door ajar for some time before removing table-
ware.
Refer to "Hints and tips" for other
possible causes.
Technical information
Dimensions Width / height / depth (mm) 600 / 850 / 625
Electrical connection
1)
Voltage (V) 220 - 240
Frequency (Hz) 50
Water supply pressure Min. / max. bar (MPa) 0.5 (0.05) / 8 (0.8)
Water supply
Cold water or hot water
2)
max 60 °C
Capacity Place settings 13
Power consumption Left-on mode (W) 5.0
Power consumption Off-mode (W) 0.50
1) Refer to the rating plate for other values.
2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to
decrease energy consumption.
12
