5/16" Cupped
Washers
Carriage Bolt
*2" Long Carriage Bolts
3/4" Long
Spare-
Shear
Bolts
Spare
Hex Lock
Nuts
][
P
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
1 Knite (to cut carton)
2 V2" Wrenches (or Adjustable Wrenches)
1 Pair of Pliers
1 9/16" Wrench (or Adjustable Wrench)
CONTENTS OF SHIPPING CARTON
5/16"
Hex
Nuts
FIGURE 1.
1. Snow Thrower—completely assembled except for
the chute crank assembly, headlight, and upper
handle which has been folded down tor shipping.
2. Chute Crank Assembly
3. Headlight Kit (small box) which contains;
1 Headlight Assembly
1 Lock Washer 5/16" I.D.
1 Hex Nut 5/16-18 Thread
2 Cable Ties
4. Hardware Pack (plastic bag) which contains the
—hardware shown in figure 1 (shown actual size),
plus one chute crank bracket which is not shown.
UNPACKING
1. Cut the four corners of the carton from top to bot
tom. Lay the panels flat on the ground.
Remove all packing inserts. Make certain ail loose
parts and literature have been removed before
discarding the inserts or carton.
The control cables may be taped to the handles
for shipping purposes only. Remove any tape that
is present.
Loosen the hand knobs on each side of the unit.
See figure 2. Raise the upper handle into operating
position. Do not tighten the hand knobs at this time.
Pull the snow thrower out of the carton by the
handle.
INSTALLING THE CHUTE CRANK
^^NOTE
Reference to right and left hand side of
the snow thrower is from the operator’s
position at the handle.
1. Secure the right hand side of upper and lower
handles and handle pane) with 2" long carriage
bolt, 5/16" cupped washer and hex nut. See figure
3. Install the carriage bolt into the lower hole with
the head of the carriage bolt to the outside. Cupped
side of washer goes against the handle panel.
Tighten securely.
Thread one 5/16" hex nut about halfway into the
eyebolt on the chute crank assembly.
Insert the eyebolt into the lower hole in the left hand
side of upper and lower handles and handle panel.
Secure with 5/16" cupped washer (cupped side of
washer goes against the handle panel) and hex
nut. Do not tighten at this time.
2.
3.
4.
5.
