Setting the rinse aid dosage
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If the Adust Sensor wash function has
been activated, the amount of rinse aid
dispensed in the Sensor wash
programme can be higher than that set.
If spots appear on crockery and
glassware:
^
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^
Switch the dishwasher off using the
On/Off button K.
^
Press the programme selector button
X in, and whilst holding it in switch
the dishwasher on with the On/Off
button K.
Keep the programme selector button
X pressed in until the lower right
hand programme indicator comes
on.
If this does not happen, start the
procedure again from the beginning.
^
Press the Turbo button three times.
The Turbo indicator will flash briefly
three times at intervals.
p3will flash in the display.
This means that the rinse aid dosage
has been set to 3 ml at the factory.
The dosage set will show in the display
after the p.
^ Use the programme selector button
X to select the rinse aid dosage you
want.
The dosage amount alters each time
you press the button.
The programmed rinse aid dosage is
now stored in memory.
^
Switch the dishwasher off using the
On/Off button K.
Before using for the first time
27
