Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^
Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off using the
K button.
^ Turn the programme selector to the
"12 o'clock" position.
^ Press the Start/Stop button J / M in,
and whilst holding it in switch the
dishwasher on using the K button.
Keep the J / M button pressed in
until the J / M indicator light comes
on.
If this does not happen, start the
procedure from the beginning again.
^
Turn the programme selector to the
"5 o'clock" position.
The 8 programme sequence indicator
will flash briefly three times at intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the 8 programme
sequence indicator flashes tells you the
rinse aid dosage which has been set
(see chart).
Rinse aid
in ml
8
Flash frequency
0-
1 Once
2 Twice
3 Three times
4 Four times
5 Five times
6 Six times
^
Use the J / M button to select the
number of flashes which equates to
the rinse aid dosage you want.
Each press of the button moves you
up a level.
The programmed rinse aid dosage is
now stored in memory.
^
Switch the dishwasher off using the
K button.
Before using for the first time
21
