
To programme the water hardness
level
Each time a button is pressed, one of
the indicator lights will flash and light
up in the control panel. However, only
the indicator lights mentioned in the
following programming process stages
are significant.
The programming procedure can be
cancelled at any time by pressing the
K button. The procedure can then be
re-started from the beginning again.
^ Switch the dishwasher off using the
K button.
^ Turn the programme selector to the
"12 o'clock" position.
^ Press the Start/Stop button J / M in,
and whilst holding it in switch the
dishwasher on using the K button.
Keep the J / M button pressed in
until the J / M indicator light comes
on.
If this does not happen, start the
procedure from the beginning again.
^
Turn the programme selector to the
"3 o'clock" position.
The 8 programme sequence indicator
will flash briefly four times at intervals
(factory default setting).
The number of times the 8 programme
sequence indicator flashes tells you the
water hardness level which has been
set (see chart).
°d
German
scale
mmol/l °f 8
Flash
frequency
1 - 4 0.2 - 0.7 2- 7 1 short
5 - 7 0.9 - 1.3 9- 13 2 short
8 - 11 1.4 - 2.0 14- 20 3 short
12 - 15 2.2 - 2.7 22- 27 4 short
16 - 20 2.9 - 3.6 29- 36 5 short
21 - 25 3.8 - 4.5 38- 45 6 short
26 - 30 4.7 - 5.4 47- 54 7 short
31 - 36 5.6 - 6.5 56- 65 8 short
37 - 45 6.7 - 8.1 67- 81 9 short
46 - 70 8.3 - 12.6 83-126 1 long
^ Use the J / M button to select the
number of flashes which equates to
your water hardness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
Example:
If your water hardness level is
4.0 mmol/l (22 °d German scale), the
8 programme sequence indicator
should flash briefly six times at
intervals.
^
Switch the dishwasher off using the
K button.
Before using for the first time
15