Problem and alarm code Possible cause and solution
The appliance does not fill with water.
• The end indicator flashes 1 time in-
termittently.
• The Start indicator flashes continu-
ously.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply
is not too low. For this information, contact your
local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
clogged.
• Make sure that the inlet hose has no kinks or
bends.
The appliance does not drain the water.
• The end indicator flashes 2 times in-
termittently.
• The Start indicator flashes continu-
ously.
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
The anti-flood device is on.
• The end indicator flashes 3 times in-
termittently.
• The Start indicator flashes continu-
ously.
• Close the water tap and contact an Authorised
Service Centre.
The appliance stops and starts more
times during operation.
• It is normal. It provides optimal cleaning results
and energy savings.
Small leak from the appliance door. • The appliance is not level. Loosen or tighten the
adjustable feet (if applicable).
• The appliance door is not centred on the tub. Ad-
just the rear foot (if applicable).
The appliance door is difficult to close. • The appliance is not level. Loosen or tighten the
adjustable feet (if applicable).
• Parts of the tableware are protruding from the
baskets.
Rattling/knocking sounds from inside
the appliance.
• The tableware is not properly arranged in the
baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
The appliance trips the circuit-beaker. • The amperage is insufficient to supply simultane-
ously all the appliances in use. Check the socket
amperage and the capacity of the meter or turn
off one of the appliances in use.
• Internal electrical fault of the appliance. Contact
an Authorised Service Centre.
Refer to "Before first use",
"Daily use", or "Hints and
tips" for other possible causes.
Once you have checked the appliance,
press Start. If the problem occurs again,
contact an Authorised Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
48 Leonard
