Using the detergent
20
30
BA D
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compartment
(A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
Using the combi detergent tablets
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and
the rinse aid dispenser.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode
to start a programme.
• Turn the programme knob until the pro-
gramme marker is aligned with a pro-
gramme on the control panel. If the on/off
indicator comes on and the phase indica-
tors for the programme start to flash, the
appliance is in setting mode.
• Turn the programme knob until the pro-
gramme marker is aligned with a pro-
gramme on the control panel. If the on/off
indicator and the start indicator come on
and a phase indicator is on with fixed
light, the appliance is not in setting mode.
To put the appliance in setting mode, press
and hold the start button until the start indi-
cator goes off and the phase indicators for
the programme start to flash.
Starting a programme
1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode.
3. Press continuously the programme but-
ton until the indicator of the programme
you want to set comes on.
4. Close the appliance door. The pro-
gramme starts.
Opening the door while the appliance
operates
If you open the door, the appliance stops.
When you close the door, the appliance
continues from the point of interruption.
Cancelling the programme
1. Open the appliance door.
2. Press and hold the programme button
until the indicator of the set programme
goes off and the end indicator flashes.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
At the end of the programme
When the programme is completed, an in-
termittent acoustic signal operates and the
end indicator comes on.
1. Press the on/off button to deactivate the
appliance.
2. Close the water tap.
30 leonard
