Once these checks have been carried out
switch on the appliance.
The programme will continue from the point
at which it was interrupted.
If the malfunction/fault code reappears or if a
fault code that is not mentioned in this manual
appears, please contact our extended
warranty administrators, refer to section
''Repairs - After Sales Service''.
The wash results are not satisfactory
The dishes are not clean • The wrong programme has been selected.
• The dishes are arranged in such a way as to stop water
reaching all parts of the surface. The baskets must not
be overloaded.
• The spray arms do not rotate freely due to incorrect
arrangement of the load.
• The filters in the base of the washing compartment are
dirty or incorrectly positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes; the
salt container is empty or the incorrect level of the water
softener has been set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
The dishes are wet and dull • Rinse aid was not used.
• The rinse aid dispenser is empty.
There are streaks, milky spots or a
bluish coating on glasses and dishes
• Decrease rinse aid dosage.
Water drops have dried onto
glasses and dishes
• Increase rinse aid dosage.
• The detergent may be the cause. Contact the detergent
manufacturer’s consumer care line.
25
