Setup Commands
^An - Printing mode
n = D, Direct thermal mode, the ribbon out sensor is disabled.
n = T, Thermal transfer mode, the ribbon out sensor is enabled.
1. If you want to change the print mode, you need to send the printing command
to the printer for changing print mode setting. There are two ways to send
printing commands to the printer. One is sending through the command
window of (GoLabel or QLabel), the other is sending through Windows
TM
HyperTerminal
TM
via RS-232 port. To send printing command, make sure that the
printer is on standby mode (LED light is green) and send below command to
change the print mode.
2. Send "^AD" command to printer to change the print mode to Direct Thermal
Mode.
3. Send "^AT" command to printer to change the print mode to Thermal Transfer
Mode. When printer is on Thermal Transfer Mode, it is necessary to install the
ribbon into printer. Otherwise the error message "Print Mode Error" will be
triggered and the printer will not be able to print.
* Note: this command will not be applied on Direct Thermal only models.
^L
…..
^Bx - Set the backward length
Description
Set the backward length to move the position of paper.
In progress
If ~S,CHECK will feedback 00
If ~Z printer would turn on immediately
If Dooropen RED light would up and motor would stop at the same time even
after printer cover close.
Example
Result :
Printer to action Motor would turn backwards 1000mm
^Cx - Number of copies per label
Set the number of copies to print for a label.
^C2
^P3
^L
C0,001,+1,Prompt
AE,10,10,1,1,0,0,^C0
001
001
002
002
003
